Water and non-shrink grout mixer with agitator
Water and non-shrink grout mixer with agitator is used for rapid mixing of pure water slurry, with water/cement ratio as low as 0.36:1, without additives. With the addition of plasticizer or superplasticizer, the ratio may be lower.
For water and non-shrink grout mixers with an agitator, it is not recommended to add mortar and sand it. For the colloid grouting mixer, the high shear high-speed mixing speed is 1450rpm, which is very fast. If there is sand in the material, the impeller may be more easily broken. It may also cause blockage.
The water and non-shrink grout mixer with agitator is the best mixing: the slurry circulates repeatedly through the high shear area in the colloid type grouting mixer. This decomposes the cement and ensures maximum dispersion of the fluid. In addition, the large-capacity colloid mixer has pressure discharge, so the materials and liquids can be transferred back to the tank for mixing and directly transferred to the mixer of the same height or the final destination.